@cm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish • 4 months agoBambu Lab’s Controversial ‘Authorization Control’ Hits Budget 3D Printersall3dp.comexternal-linkmessage-square24fedilinkarrow-up176arrow-down11
arrow-up175arrow-down1external-linkBambu Lab’s Controversial ‘Authorization Control’ Hits Budget 3D Printersall3dp.com@cm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish • 4 months agomessage-square24fedilink
minus-square@empireOfLove2@lemmy.dbzer0.comlinkfedilinkEnglish13•4 months agoI have not updated my x1 firmware and never will be.
minus-square@teuto@lemmy.teuto.iculinkfedilinkEnglish14•4 months agoI blocked mine from the internet for good measure too.
minus-square@Bronzie@sh.itjust.workslinkfedilinkEnglish2•4 months agoI did this, but experienced a lot of issues connecting to it afterwards. Constant disconnects and it taking several minutes after opening Orca/Studio to find it. Any advice, as I’d like to go back to LAN Mode? Cheers
minus-square@Zeoic@lemmy.worldlinkfedilinkEnglish5•4 months agoI currently have my P1S in LAN mode and use HomeAssistant to control it, using thr ha-bambulab integration. Does everything I need
minus-square@Bronzie@sh.itjust.workslinkfedilinkEnglish1•4 months agoCheers, HA integration is on the plan for the future, I just strugle with time these days with a small kid and work.
minus-square@Bluewing@lemmy.worldlinkfedilinkEnglish2•4 months agoRoll back the firmware to a version that worked. You still can do that.
minus-square@Bronzie@sh.itjust.workslinkfedilinkEnglish1•edit-24 months agoI wish I could. Need the newer FW to use the drying function of the AMS2. I’m considering going back to LAN and just dealing with it though. I really prefer Orca over Studio
minus-square@bluewing@sh.itjust.workslinkfedilinkEnglish2•4 months agoIt would appear you are now trapped by Bambu into their product system. May God ha’ Mercy on your Soul.
I have not updated my x1 firmware and never will be.
I blocked mine from the internet for good measure too.
I did this, but experienced a lot of issues connecting to it afterwards. Constant disconnects and it taking several minutes after opening Orca/Studio to find it.
Any advice, as I’d like to go back to LAN Mode?
Cheers
I currently have my P1S in LAN mode and use HomeAssistant to control it, using thr ha-bambulab integration. Does everything I need
Cheers, HA integration is on the plan for the future, I just strugle with time these days with a small kid and work.
Roll back the firmware to a version that worked. You still can do that.
I wish I could.
Need the newer FW to use the drying function of the AMS2.
I’m considering going back to LAN and just dealing with it though. I really prefer Orca over Studio
It would appear you are now trapped by Bambu into their product system.
May God ha’ Mercy on your Soul.