I’d like to add a smart button to my HA setup. I don’t have zigbee signal nearby, so I’m wondering what the best way to do this would be.

I’m using a Skyconnect dongle. There’s wifi nearby. I want to control a smart switch nearby, which would also have zigbee but that also wouldn’t reach the distance I need.

Is Matter a solution here? With a hub connected to wifi that bridges to the button?

Any suggestions on hardware?

Or any other suggestions?

  • Dave@lemmy.nzOPEnglish
    1·
    10 months ago

    If it’s in relay mode, does it only need power via USB or does it still need to be plugged into a server? I don’t have any nearby devices to plug it into, I’d probably need to get some mishmash of USB charger and adapter to plug in the coordinator and power it, if it can’t reach straight from my HA server all the way to where I want to put the button.

    • thegreekgeek@midwest.socialEnglish
      2·
      10 months ago

      Yeah, it shouldn’t need anything more than USB power, it’s just another node in the mesh at that point. If you don’t have one of those USB outlets just use a phone brick, that should be enough.

      EDIT: See THIS for more info. While that’s obviously written for Z2M some of it applies to other coordinators.

      • Dave@lemmy.nzOPEnglish
        1·
        10 months ago

        Sweet, I’ll have a think of where I could put one. Any idea of range for ones that have an antenna?

        • thegreekgeek@midwest.socialEnglish
          2·
          10 months ago

          The product page for the sonoff dongle says 40-50 meters line-of-sight but it’ll depend on your walls and wifi interference.

          • Dave@lemmy.nzOPEnglish
            1·
            10 months ago

            Oh cool, thanks. None of the ones I looked at showed range info that I could see. It has to travel through a few walls, but I’m sure one will do the job with the right placement.